Configure an egress map
An example of how to use an egress map to set DSCP values on packets, after classification.
dp0xe6
, and that have a designation of 0
, the egress map called fred
will cause them to have their DSCP value set to 15
.Supported platforms
list_alt
fred
such that any packet with a DSCP value that belongs to dscp-group group-1
will have its DSCP value set to 15
.user@system# set policy egress-map fred dscp-group group-1 dscp 15
dp0xe6
such that any packet that is sent out of this interface has its DSCP value updated in accordance with the egress map called fred
.If the hardware platform is configured for switch mode:
user@system# set interfaces dataplane dpxe6 switch-group port-parameters policy egress-map fred
If the hardware platform is configured for router mode:
user@system# set interface dataplane dp0ce0 policy egress-map fred
dp0xe6
, and that have a designation of 0
, the egress map called fred
will cause them to have their DSCP value set to 15
.Get Started An introduction to the Ciena Vyatta NOS
The Vyatta NOS Overview Get to know more about how Vyatta NOS is the best solution
Vyatta NOS Architecture Overview An overview of the Vyatta NOS system architecture
Troubleshooting Guide Identify common issues with your configuration and network setup
Copyright © 2023 Ciena Corporation. All rights reserved