show system boot-messages
Displays bootup messages generated by the kernel.
A subset of the full list of kernel bootup messages is displayed.
- all
- Displays all kernel bootup messages.
Operational mode
Use this command to see bootup messages that have been generated by the kernel.
The following example shows how to display bootup messages that have been generated by the kernel.
vyatta@R1:~$ show system boot-messages
Linux version 2.6.23-1-486-Vyatta (autobuild@sydney) (gcc version 4.2.3 20071123 (prerelease) (Debian 4.2.2-4)) #1 SMP Fri Jan 18 07:17:50 PST 2008
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000001fee0000 (usable)
BIOS-e820: 000000001fee0000 - 000000001fee3000 (ACPI NVS)
BIOS-e820: 000000001fee3000 - 000000001fef0000 (ACPI data)
BIOS-e820: 000000001fef0000 - 000000001ff00000 (reserved)
BIOS-e820: 00000000fec00000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
510MB LOWMEM available.
found SMP MP-table at 000f5a20
Entering add_active_range(0, 0, 130784) 0 entries of 256 used
Zone PFN ranges:
DMA 0 -> 4096
Normal 4096 -> 130784
HighMem 130784 -> 130784
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0 -> 130784
On node 0 totalpages: 130784
: