home

Supported platforms

Getting startedOverviewArchitectureSupported platformsRelease notesWhite papers
Getting startedOverviewArchitectureSupported platformsRelease notesWhite papers

Vyatta documentation

Learn how to install, configure, and operate the Vyatta Network Operating System (Vyatta NOS) and Orchestrator, which help drive our virtual networking and physical platforms portfolio.

Show On this page:

thumbnailSupported platforms

Installing vCPE

Installing the software

You can install the software after you download the ISO file and create a LiveCD or LiveUSB disk.

To install the software, perform the following steps.

  1. Create and run LiveCD or LiveUSB.
  2. Log in using a username of vyatta and a password of vyatta.
  3. Enter a username for the administrator account.
    Note: If you do not enter a username for the administrator account, the device uses the default username, vyatta.
  4. Enter a password for the new username that you provided for the administrator.
  5. When the installation is completed, remove the LiveCD or LiveUSB disk.
  6. Set the BIOS to boot from the device on which the system is now installed.
  7. Reboot the system.
  8. Test the installation.

Last updated: May 7, 2021