show vrrp detail
Displays details about all the VRRP groups that are configured at the system level.
- detail
- Specifies the display of detailed VRRP information.
Operational mode
Use this command to display information about all the VRRP groups configured at the system level.
Use this command to show the status of the tracked path/monitor pairs.
The system automatically generates a name for the VRRP interface by appending vrrpn (where n is an arbitrary number starting from 1) to the physical interface prefix, for example, dp0vrrp1.
The interface name is based on the highest existing interface; for a scenario in which you configure three groups (dp0vrrp1, dp0vrrp2, and dp0vrrp3), then delete dp0vrrp2 and create another group, the interface name for the new group is dp0vrrp4.
Last transition
shows either the last state transition or last time the keepalived configuration was read. The following example shows how to display information about all the VRRP groups configured at the system level.
vyatta@vyatta:~$ show vrrp detail
--------------------------------------------------
Interface: dp0p1s2
--------------
Group: 1
----------
State: MASTER
Last transition: 2m46s
Version: 3
RFC Compliant
Virtual MAC interface: dp0vrrp1
Address Owner: no
Source Address: 10.10.3.2
Configured Priority 200
Effective Priority 210
Advertisement interval: 1000 milli-sec
Preempt: enabled
Accept: disabled
Tracked Path Monitor count: 1
test_monitor
test_policy COMPLIANT weight 10
VIP count: 1
10.10.1.100/32