home

Supported platforms

Getting startedOverviewArchitectureSupported platformsRelease notesWhite papers
Getting startedOverviewArchitectureSupported platformsRelease notesWhite papers

Vyatta documentation

Learn how to install, configure, and operate the Vyatta Network Operating System (Vyatta NOS) and Orchestrator, which help drive our virtual networking and physical platforms portfolio.

Show On this page:

thumbnailSupported platforms

L2TPv3 Data Plane Interfaces Commands

interfaces l2tpeth <lttpN> l2tp-session remote-session-id <id>

Specifies a remote session identifier of an L2TPv3 tunnel interface.

set interfaces l2tpeth lttpN l2tp-session remote-session-id id
delete interfaces l2tpeth lttpN l2tp-session remote-session-id id
lttpN
L2TPv3 static L2TPv3 tunnel interface. The interface ranges from lttp0 through lttpN, where N is a non-negative integer.
id
Remote session identifier of the interface. The identifier ranges from 0 through 4294967295.

Configuration mode 


interfaces {
     l2tpeth lttpN {
          l2tp-session {
               remote-session-id id
          }
     }
}

Use the set form of this command to specify a remote session identifier of an L2TPv3 tunnel interface.

Use the delete form of this command to remove a remote session identifier from an L2TPv3 tunnel interface.

Last updated: May 7, 2021