Vyatta NOS documentation

Learn how to install, configure, and operate Vyatta Network Operating System (Vyatta NOS), which helps to drive our virtual networking and physical platforms portfolio.

interfaces dataplane <interface-name> vif <vif-id> ipv6 disable

Disables IPv6 on a vif.

set interfaces dataplane interface-name vif vif-id ipv6 disable
delete interfaces dataplane interface-name vif vif-id ipv6 disable
show interfaces dataplane interface-name vif vif-id ipv6 disable
interface-name
The name of a data plane interface. For more information about the supported interface name formats, refer to Data Plane Interface.
vfi-id
The ID of a vif. The ID ranges from 1 through 4094.

Configuration mode.

interfaces {
     dataplane interface-name {
        vif vif-id {
           ipv6 {
              disable
           }
        }
     }

By default, IPv6 is enabled on all interfaces. A global command exists which can disable IPv6, namely set system ipv6 disable, and this will take precedence over any of the existing per-interface based, IPv6 commands.

IPv6 Forwarding can be disabled via the interfaces dataplane <interface-name> vif <vif-id> ipv6 disable-forwarding command, but note that IPv6 traffic can still be terminated on this interface.

IPv6 configuration can be totally disabled via the interfaces dataplane <interface-name> vif <vif-id> ipv6 disable command.

Use the set form of this command to disable IPv6 on this interface.

Use the delete form of this command to enable IPv6 on this interface.

Use the show form of this command to display the current IPv6 configuration on this interface.