Vyatta Network OS Documentation

Learn how to install, configure and operate the Vyatta NOS, which helps drive our virtual networking & physical platforms portfolio.

interfaces <interface> ipv6 mld last-member-query-count <count>

Manually sets the last member query count value.

set interfaces interface ipv6 mld last-member-query-count count
delete interfaces interface ipv6 mld last-member-query-count
show interfaces interface ipv6 mld last-member-query-count

The router sends two Query messages, after which it considers the host to have left the group.

interface
The type of interface. For a list of supported interfaces and detailed syntax, see interfaces <interface> ipv6 mld.
count
The number of times the router sends a Query message after receiving a Leave message. The range is 2 to 7. The default is 2.

Configuration mode


interfaces interface {
    ipv6 {
        mld {
            last-member-query-count count
        }
    }
}

Use this command to set the number of times that the router sends a group-specific or source-group specific Query message when it receives a Leave message from a receiver host.

This command applies to interfaces configured for MLD Layer 3 multicast protocols.

The router uses this Query to determine whether any members of the multicast group remain on the network. The command is sent at the interval set in interfaces <interface> ipv6 mld last-member-query-interval <interval>. If the router receives no response to the configured number of queries, the router stops forwarding to that network.

Use the set form of this command to set the number of last-member queries sent.

Use the delete form of this command to restore the default value for last-member queries.

Use the show form of this command to show last-member query configuration.