protocols ospf redistribute rip
Sets the parameters for redistribution of RIP routes into OSPF.
RIP routes that are redistributed into OSPF are assigned a routing metric of 1 and a metric type of 2. By default, no route map is applied to redistributed RIP routes.
- process pid
- Specifies the PID of an IPv4 OSPF process.
- metric metric
- Applies the specified metric to RIP routes that are redistributed into OSPF. The metric ranges from 1 through 16. The default metric is 1.
- metric-type type
- The metric type of an external route, which specifies how cost is calculated, to associate with the Type 5 default link-state advertisement (LSA). The metric type is either of the following:
1: Adds internal cost to external cost. (E1 routes use the redistributed cost plus the cost to the ASBR.)
2: Uses only external cost. (E2 routes use only the redistributed cost.)
The default type is 2.
- route-map map-name
- Redistributes routes that satisfy the specified route map.
Configuration mode
protocols {
ospf {
process pid {
redistribute {
rip {
metric metric
metric-type type
route-map map-name
}
}
}
}
}
Use this command to set the parameters for redistribution of Routing Information Protocol (RIP) routes into OSPF.
The inverse mask of the source field is applied to the prefix prior to the comparison with the source. The inverse mask for the destination field is applied to the net mask of the prefix prior to the comparison with the net-mask as specified in the destination field.
Effectively, the prefix must match the source with the application of inverse mask of the source field. And the net mask for the prefix must match the destination with the application of the inverse mask of the destination field.
Use the set form of this command to set the parameters for redistribution of RIP routes.
Use the delete form of this command to remove the parameters for redistribution of RIP routes.
Use the show form of this command to display the parameters for redistribution of RIP routes.