Vyatta NOS documentation

Learn how to install, configure, and operate Vyatta Network Operating System (Vyatta NOS), which helps to drive our virtual networking and physical platforms portfolio.

interfaces dataplane <dpxx> policy route pbr <name>

Applies a PBR policy to inbound traffic on a data plane interface.

set interfaces dataplane dpxx policy route pbr name
delete interfaces dataplane dpxx policy route pbr [ name ]
show interfaces dataplane dpxx policy route pbr [ name ]
dpxx
The name of a data plane interface, where dpx specifies the data plane identifier (ID). Currently, only dp0 is supported.
name
The name of a PBR policy.

Configuration mode


interfaces dataplane interface { 
    policy {
        route {
            pbr name
        }
    }
}

A routing policy has no effect on traffic traversing the system until it has been applied to an interface.

To use the policy-based routing feature, you must define a routing policy by using the set policy route pbr name rule number command, and then apply the routing policy to interfaces by using the interfaces dataplane dpxx policy route pbr name command. Once applied, the rule set acts as a packet filter.

Use the set form of this command to apply a PBR policy to an interface.

Use the delete form of this command to remove a PBR policy, or all PBR policies, from an interface.

Use the show form of this command to display a PBR policy configuration, or all PBR policy configurations, for an interface.