Vyatta NOS documentation

Learn how to install, configure, and operate Vyatta Network Operating System (Vyatta NOS), which helps to drive our virtual networking and physical platforms portfolio.

interfaces dataplane <dpxx> vif <vif-id> policy route pbr <name>

Applies a PBR policy to a virtual interface of a data plane.

set interfaces dataplane dpxx vif vif-id policy route pbr name
delete interfaces dataplane dpxx vif vif-id policy route pbr [ name ]
show interfaces dataplane dpxx vif vif-id policy route pbr [ name ]
dpxx
The name of a data plane interface, where dpx specifies the data plane identifier (ID). Currently, only dp0 is supported.
vif-id
A virtual interface (vif) ID. The ID ranges from 1 through 99999.
name
The name of a PBR policy.

Configuration mode


interfaces {
        dataplane interface-name {
                vif vif-id {
                        policy {
                                pbr policy-name
                        }
                }
        }
}

A routing policy has no effect on traffic traversing the system until it has been applied to an interface.

To use the policy-based routing feature, you must define a routing policy by using the set policy route pbr name rule number command, and then apply the routing policy to interfaces by using the set interfaces dataplane dpxx vif vif-id policy route pbr name command. Once applied, the rule set acts as a packet filter.

Use the set form of this command to apply a PBR policy to an interface.

Use the delete form of this command to remove a PBR policy, or all PBR policies, from an interface.

Use the show form of this command to display a PBR policy configuration, or all PBR policy configurations, for an interface.