interfaces vti <vtix> policy route pbr <name>
Applies a PBR policy to inbound traffic on a virtual tunnel interface.
- vtix
- The identifier of a virtual tunnel interface. The identifier ranges from vti0 through vtix, where x is a nonnegative integer.
- name
- The name of a PBR policy.
Configuration mode
interfaces vti {
policy {
route {
pbr name
}
}
}
A routing policy has no effect on traffic traversing the system until it has been applied to an interface.
To use the policy-based routing feature, you must define a routing policy by using the set policy route pbr name rule number command, and then apply the routing policy to interfaces by using the interfaces vti vtix policy route pbr name command. Once applied, the rule set acts as a packet filter.
Use the set form of this command to apply a PBR policy to an interface.
Use the delete form of this command to remove a PBR policy, or all PBR policies, from an interface.
Use the show form of this command to display a PBR policy configuration, or all PBR policy configurations, for an interface.