Configuring MPLS RSVP global settings
How to configure MPLS RSVP global settings
To configure global MPLS RSVP settings, perform one or more of the following steps in configuration mode.
- To create a name to value binding for an administrative group, enter the protocols mpls-rsvp globals admin-groups <name> value <0-31> command. This can be referenced by an interface or a path affinity.
vyatta@R1# set protocols mpls-rsvp globals admin-groups group8 value 1
- To create an explicit path definition, enter the protocols mpls-rsvp globals explicit-paths <name> command. This can be referenced by a tunnel primary or secondary session. It describes a full or partial path that the session must take. Changes to the path will result in make-before-break sessions being re-established with the new information.
vyatta@R1# set protocols mpls-rsvp globals explicit-paths <name>
- To create an explicit route object for a path at a position indicated by the index value, enter the protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects <0-255> command.
vyatta@R1# set protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects 8
- To create an explicit route object that is a loose next hop, enter the protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects <0-255> action loose command. The explicit route object is a loose next hop - it doesn't have to immediately follow the preceding hop.
vyatta@R1# set protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects 8 action loose
- To create an explicit route object that is a strict next hop, enter the protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects <0-255> action strict command. The explicit route object is a strict next hop - it must immediately follow the preceding hop.
vyatta@R1# set protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects 8 action strict
- To configure the address of the next hop in the path, enter the protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects <0-255> address <x.x.x.x> command.
vyatta@R1# set protocols mpls-rsvp globals explicit-paths <name> explicit-route-objects 8 address 10.10.10.10
- To enable periodic reoptimization of tunnels, enter the protocols mpls-rsvp globals reoptimization command. The default reoptimization time is 3600 seconds. If reoptimization is not enabled, a session will remain on its current path even if a better path becomes available.
vyatta@R1# set protocols mpls-rsvp globals reoptimization
- To configure a specific reoptimization interval in seconds, enter the protocols mpls-rsvp globals reoptimization interval <0..604800> command.
vyatta@R1# set protocols mpls-rsvp globals reoptimization interval 30
- To configure use of an explicit-null label at the tail end, enter the protocols mpls-rsvp globals tail-signaling explicit-null command. The default is to use implicit-null.
vyatta@R1# set protocols mpls-rsvp globals tail-signaling explicit-null