show mpls ldp igp sync
Displays the MPLS LDP interfaces configured for IGP synchronization.
Operational mode
Use this command to display the MPLS LDP interfaces configured for IGP synchronization. See also show ip ospf interface for LDP-OSPF sync configuration, where the initial cost of 65535 is used until IGP synchronization is achieved.
The following example shows how to display the MPLS LDP interfaces configured for IGP synchronization.
vyatta@vyatta:~$ show mpls ldp igp sync
lo is up, line protocol is up
LDP not configured; LDP-IGP Synchronization not enabled.
dp0s4 is up, line protocol is up
LDP not configured; LDP-IGP Synchronization not enabled.
dp0p1s1 is up, line protocol is up
LDP configured; LDP-IGP Synchronization enabled.
Session IP Address : 3.3.3.3
Sync status: Achieved
Delay timer: Configured, 40 seconds, Not Running
dp0p1s2 is up, line protocol is up
LDP configured; LDP-IGP Synchronization enabled.
Session IP Address : NONE
Sync status: Not achieved
Delay timer: Configured, 40 seconds, Not Running