Vyatta Network OS Documentation

Learn how to install, configure and operate the Vyatta NOS, which helps drive our virtual networking & physical platforms portfolio.

security vpn l2tp remote-access server-ip-pool stop <ipv4>

Specifies the ending address of a pool of IP addresses for an L2TP server.

set security vpn l2tp remote-access server-ip-pool stop ipv4
delete security vpn l2tp remote-access server-ip-pool stop
show security vpn l2tp remote-access server-ip-pool stop

The default ending address is 10.255.255.255.

ipv4
The IP address that designates the end of the address pool.

Configuration mode

security {
       vpn {
          l2tp {
             remote-access {
                server-ip-pool {
                       stop ipv4
             }
          }  
       } 
    }
}

Use this command to specify the ending address of a pool of IP addresses for an L2TP server. Each L2TP VPN connection requires a client address and a server address. Both the beginning and ending addresses for the L2TP server must be specified. Use the security vpn 12tp remote-access server-ip-pool start ipv4 command to specify the beginning address for the L2TP server.

For information on how to specify the range of addresses for L2TP VPN clients, refer to the security vpn 12tp remote-access client-ip-pool start ipv4 and security vpn 12tp remote-access client-ip-pool stop ipv4 commands.

Note: The number of addresses that are used in the range for the L2TP server must be equal to or greater than the number of addresses that are used in the range for the L2TP VPN clients. And the address range that is used for L2TP server must be unique within your router configuration.
Note: If you do not specify the beginning and ending addresses of a pool of IP addresses for an L2TP server, the Vyatta router uses a default address range from 10.255.0.0 through 10.255.255.255. If you use the default range, ensure that this range is unique within your router configuration.

Use the set form of this command to specify the ending address.

Use the delete form of this command to delete the ending address.

Use the show form of this command to display the ending address.