Vyatta Network OS Documentation

Learn how to install, configure and operate the Vyatta NOS, which helps drive our virtual networking & physical platforms portfolio.

interfaces openvpn <vtunx> server client <client-name> ip <ipv4>

Specifies the IP address of a client in a remote access environment.

set interfaces openvpn vtunx server client client-name ip ipv4
delete interfaces openvpn vtunx server client client-name ip
show interfaces openvpn vtunx server client client-name ip
vtunx
The identifier for the OpenVPN interface. This may be vtun0 to vtunx, where x is a non-negative integer.
client-name
Mandatory. The “name” of the client. It corresponds to the “common name” contained in the client's certificate. When a client initiates the VPN session, the server uses the name in the certificate to look up and apply client-specific settings (if any).
ipv4
The IP address to be assigned to the client.

Configuration mode

interfaces {
    openvpn vtunx {
        server {
            client client-name {
                ip ipv4
            }
        }
    }
}

Use this command to specify the IP address to assign to the client in a remote access environment.

Note: Committing configuration changes to this configuration node does not result in the OpenVPN process being restarted. The configuration change will take effect the next time the client connects to the server.

Use the set form of this command to specify the IP address to assign to the client in a remote access environment.

Use the delete form of this command to remove the IP address.

Use the show form of this command to view the IP address.