Supported platforms

Vyatta documentation

Learn how to install, configure, and operate the Vyatta Network Operating System (Vyatta NOS) and Orchestrator, which help drive our virtual networking and physical platforms portfolio.

Configuring BFD for BGP

This section describes the procedure for configuring BFD for BGP single hop and multiple hop, so that BGP is a registered protocol with BFD and receives detection-failure messages about the forwarding path. Implementing BFD for BGP results in fast convergence timings.

Note: BFD is supported for both iBGP and eBGP. All these configurations are for BFD over iBGP. For BFD over eBGP, remote-as (asn) can be modified with remote system (asn) for both single-hop and multiple-hop BFD. The eBGP multiple-hop (hopcount) is configured with the required hop count for eBGP mutiple-hop BFD.
Note: BFD for BGP is supported for both IPv4 and IPv6 addressing.