Vyatta NOS documentation

Learn how to install, configure, and operate Vyatta Network Operating System (Vyatta NOS), which helps to drive our virtual networking and physical platforms portfolio.

interfaces bridge <brx> spanning-tree

Enables spanning tree protocol on a bridge group.

set interfaces bridge brx spanning-tree
delete interfaces bridge brx spanning-tree
show interfaces bridge brx spanning-tree

Spanning tree protocol is disabled.

brx
The ID of bridge group.
spanning-tree
Specifies the Spanning Tree Protocol.

Configuration mode


interfaces {
	  bridge brx {
		     spanning-tree
	  }
}

Use this command to enable the IEEE 802.1D Spanning Tree Protocol (STP) on a bridge group. When STP is enabled on a bridge group, it is enabled for all interfaces and vifs assigned to the bridge group.

Use the set form of this command to enable STP on a bridge group.

Use the delete form of this command to restore the default state of STP on a bridge group; that is, STP is disabled..

Use the show form of this command to view the STP configuration on a bridge group.