Configuring network addresses
The system automatically creates and addresses the loopback interface, so you do not need to configure any additional addressing. If you delete the loopback node, the system re-creates and readdresses the loopback address again the next time the system starts.
You may at times want to configure a smaller network prefix than /8 to the loopback interface. The example in this section shows how to assign the 192.168.75.1/32 address to the loopback interface. When you finish the example, the interface is configured as in the following figure.
To configure the loopback interface, perform the following steps in configuration mode.
Step |
Command |
---|---|
Assign the IP address to the loopback interface. |
|
Commit the configuration. |
|
View the configuration. |
|