service telnet
Configures Telnet as an access protocol on the system.
Configuration mode
service {
telnet {
}
}
Use this command to configure the system to accept Telnet as an access service to the system.
Creating the Telnet configuration node enables Telnet as an access protocol. By default, the system uses port 23 for the Telnet service.
Use the set form of this command to create the Telnet configuration.
Use the delete form of this command to remove the Telnet configuration. If you delete the Telnet configuration node you will disable Telnet access to the system.
Use the show form of this command to view the Telnet configuration.