Configuration commands
The Commands section describes the L2TPv3 tunnel and LAC configuration commands. The section also describes the L2TPv3 show commands.
For LNS commands, the L2TPv3 feature supports the following command options for the set interfaces l2tpeth lttpN command. You can use these command options to configure LNS tunnels. These command options are similar to the options for the set interfaces dataplane dp_interface command.
Command option |
Description |
---|---|
address |
Specifies the IPv4 or IPv6 address of a tunnel interface. |
bridge-group |
Adds and configures a bridge group for a tunnel interface. |
description |
Provides a description of a tunnel interface. |
disable |
Disables a tunnel interface. |
firewall |
Specifies firewall options. |
ip |
Specifies IPv4 parameters. |
ipv6 |
Specifies IPv6 parameters. |
mtu |
Specifies the maximum transmission unit (MTU). |
policy |
Specifies the policy settings for a tunnel interface. |
vif |
Specifies the identifier of a VIF interface for a tunnel. |