service snmp trap-target <addr>
Specifies the IP address and port of the destination for SNMP traps.
- addr
- Optional. Multi-node. The IPv4 or IPv6 address of the destination for SNMP traps.
You can specify multiple destinations for SNMP traps by creating multiple trap-target configuration nodes. Or, you can enter a space-separated list of IP addresses.
- community
- The community used when sending trap information. The default community is public.
- port
- The destination UDP port used for trap notification. The default port is 162.
Configuration mode
service {
snmp {
trap-target addr {
community community
port port
}
}
}
Use this command to specify the IPv4 or IPv6 address and port of the destination for SNMP traps as well as the community used when sending trap information.
Use the set form of this command to specify trap-target parameters.
Use the delete form of this command to remove trap-target parameters.
Use the show form of this command to view the trap-target configuration.