show monitoring
This command displays the current monitor debugs that have been enabled. It complements the monitor command.
Example: show monitoring
Note: It is very
common for new network administrators to apply protocol debugging to assist in troubleshooting, and to then forget to disable the it after
the problem is resolved. Remember to disable debugging to ensure optimum system performance.
$OS_PROMPT$ monitor protocol bgp enable all
$OS_PROMPT$ show monitoring
------------------------------
Protocol monitoring status
------------------------------
BFD debugging status:
BFD ipc-event debugging is on
BGP debugging status:
BGP debugging ALL on
BGP debugging is on
BGP Bidirectional Forwarding Detection is on
BGP Route Flap Dampening debugging is on
BGP events debugging is on
BGP graceful-restart debugging is on
BGP filter debugging is on
BGP fsm debugging is on
BGP keepalives debugging is on
BGP msdp debugging is on
BGP nht debugging is on
BGP nsm debugging is on
BGP rib debugging is on
BGP RT Filter debugging is on
BGP Additional Paths debugging is on
BGP Authentication debugging is on
BGP updates debugging is on
BGP MPLS debugging is on
NSM debugging status:
No global or default VRF debugging enabled
RIB debugging status:
No global or default VRF debugging enabled